Industry News

Car condenser cleaning steps

2022-05-20
1. Mix the detergent with water. The washing product of the condensing net is alkaline and is slightly corrosive to the condenser, so it is very important to add water to reduce the concentration, because if the concentration is too high, the tube will be washed very cleanly, but the corrosiveness cannot be ignored.

2. Start the car, turn on the air conditioner, and make the electronic fan rotate. Rinse with clean water first, and use the rotation of the fan to spread the clean water all over the condenser. It must be flushed thoroughly. During this period, the electronic fan may stop due to the low temperature of the condenser. At this time, stop the flushing and let the condenser. The temperature rises, causing the electronic fan to run again.

3. After the entire condenser is soaked, use a water spray tool (such as watering flowers, etc.) to spray the washed product on the surface of the condenser. At this time, the electronic fan should also be running, and use it Its operation is sucked in and distributed to all corners, and it is estimated that it is enough to spray it. At this time, turn off the air conditioner and engine, observe the surface of the condenser, and after a few minutes, you will see that the dirt on the surface will slowly "float", accompanied by some small bubbles, wait for a few minutes (we usually wait ten to ten fifteen minutes, depending on the concentration).

4. Start the air conditioner again to make the fan rotate. At this time, use a lot of water to rinse. The more thorough the rinse, the better. Don't be lazy in this step. After the rinse is enough, you will find that the surface of the condenser is clean. Wash the condenser like new.

We use cookies to offer you a better browsing experience, analyze site traffic and personalize content. By using this site, you agree to our use of cookies. Privacy Policy
Reject Accept